首页--新闻列表

汕头潮阳艾尔福德环氧清通告诉您清通表面有刷痕

环氧清通表面刷痕产生的原因:

A、施工原因:施工方法错误,涂料搅拌后施工时间过长,滚刷均匀,涂层薄厚控制不到位。

B、工具原因:滚筒质量不合格,滚筒表面处理有误。

汕头潮阳国辉防水补漏公司

C、涂料本身的原因:主要是涂料的流平性差,涂料的粘度过高。有触变性的填料或助剂。

解决的方法:

A、注意施工方法,涂料的汕头潮阳保洁公司熟化时间不要过长。滚筒的二端到圆角,涂层的一遍厚度尽可能不要小于0.15mm。

B、买好一点的滚筒,滚筒使用前用胶带处理一下滚筒表面

C、涂料的原因,增加涂料的流平性,降低涂料的粘度,尽可能减少有触变性的填料和助剂,特别要注意墙面涂料的流平剂用在清通涂料的现象。

The causes of floor surface brush marks:
A, the construction: construction method error, coating construction time is too long, after mixing uniform roller, coating and its thickness control does not reach the designated position.
B, tool reason: quality unqualified roller, roller surface treatment is wrong.
C, the cause of the coating itself: mainly poor flowing property of paint, paint viscosity is too high. Has thixotropy fillers or additives.
The solution:
A, pay attention to the construction methods, coating curing time not too long. The two end of the cylinder to the rounded corners, coating thickness again as far as possible do not less than 0.15 mm.
B, bought a bit of roller, roller tape with the roller surface before using
C, coating, increase the coating flow property, lower the viscosity of the coating, minimize has thixotropy fillers and additives, special attention should be paid to metope paint flow ping agent on the phenomenon of floor coating.
http://www.g6pz.com/g6pz/04e9-12.htm

 

上一篇::       下一篇:

欢迎访问汕头潮阳嘉文清通公司电话。2018-01-31 本站主要介绍汕头潮阳嘉文清通公司电话 汕头濠江区畅捷清通公司 汕头潮南瑞通清通公司 汕头潮阳清通公司价格 汕头潮阳清通公司电话汕头潮阳嘉文清通公司新打折促销资讯. 网站地图